SHAPE_ARC::IntersectLine() fails when one of the arcs start points
is on the center point of the other -- in this case we can't extend
the line to the arc intersection because one point does not define
a line....
Fixes https://gitlab.com/kicad/code/kicad/issues/12609
This also fixes a failure to use the correct effective width for
shapes (which might, for instance, inherit their widths from schematic
defaults, netclasses, etc.).
Fixes https://gitlab.com/kicad/code/kicad/issues/11358
The edge case is when the segment is completely contained inside the arc
(This partially reverts b4835c82085a074c0ee00247504055ee063da963 and
adds the missing test cases)
The arc2segment collision should at also include the arc endpoint projections on the segment being tested. Not sure it covers all possible cases, though.
Fixes: https://gitlab.com/kicad/code/kicad/-/issues/9023
This ensures that the arc shapes remain correct after removing
a point belonging to an arc or inserting a point in the middle
of an arc.
Simplify implementation of Replace( ..., aP ). Now a Remove
operation followed by an Insert operation.
Improve QA test for SHAPE_LINE_CHAIN Append, Insert and Replace
Implement SHAPE_LINE_CHAIN::splitArc to break up an arc into two
Implement SHAPE_ARC::ConstructFromStartEndCenter and add qa test
- Some are related to shape errors when the allowed error to approximate circle
by segment is large and arc radius small.
- fix the actual error used in ConvertToPolyline().
- Use SHAPE_ARC::DefaultAccuracyForPCB() instead of a fixed value as extra margin
in zones. It should not change something, because it is also a fixed value
(5 micrometers), but it is not a magic number.
-TransformArcToPolygon() fix some issues and add a new algo, based on the arc actual
outline shape (initial algo is still available in code, just in case).
Arcs with small radius can be approximated with very few segments.
However, if the thickness is large, relative to the radius, the approximation
must be based on the external radius, not the arc radius.
The difference can be significant.
This is especially noticeable for these graphic arcs in filled zones.
We were discarding shapes too aggressively for having a
larger area than a shape underneath.
Let's also try showing fewer disambiguation menus, in particular
always preferring items on the active layer when the candidates
include overlapping items of similar area on other layers.
Fixes https://gitlab.com/kicad/code/kicad/-/issues/7949
1) Tests can't expect accuracies around 1 to work. PCBNew defaults
to 5000.
2) Tests shouldn't artifically expand tolerance just to match the
results.
3) Tests should guarantee that end point is on arc, not just close
to it.
4) Standard polygonization of a circle is inside so splitting the
error needs to increase radius, not decrease.
5) Special-case first and last points so that they're exact.
1) An actual distance of 0 is still a collision, even if the allowed
distance is 0.
2) Be consitent about edges and interiors. Everyone expect the edge
of a RECT to be part of the RECT; same with a CIRCLE. SHAPE_POLY_SET
shouldn't be any different. (And SHAPE_LINE_CHAIN was a split-
personality with the edge considered part of it for Collide() but not
for PointInside()).
