We had some spurious bugs where both ends would get dragged to a
single point (making them disappear). While I never caught it
in the debugger, I'm guessing that the flags weren't getting
cleared properly or were getting overwritten or something. Anyway,
it now uses std::pair instead.
Fixes https://gitlab.com/kicad/code/kicad/issues/6550
Fixes https://gitlab.com/kicad/code/kicad/issues/6431
This also removes vector cover types which do nothing except obfuscate
the underlying implementation.
Mainly changes SCH_SHEET_PINS and CONFIG_PARAM_ARRAY (which will soon
be replaced by Jon's new stuff).
This moves EESchema DLIST structures to rtree. These changes are more
fundamental than the pcbnew changes from 9163ac543 888c01d11 d1877d7c1
and 961b22d60 as eeschema operations were more dependent on passing
drawing list references around with SCH_ITEM* objects.
The point editor expects rectangles with a height and width > 0.
Previously, this constraint did not exist,
so some LIB_RECTANGLE graphic items can create issues when trying to move a corner.
Now, the LIB_RECTANGLE graphic item is normalized before trying to move a corner.
This is based on the notion that in Kicad the start and end-points
are far more important (as they usually connect to other segments)
than the center is.
Includes the addition of an onSetCursor() handler which must be called
from both the GAL canvas AND the GAL backend (at least on OSX) to prevent
cursor flickering between (for instance) pencil and arrow.
Also includes new architecture for point editors which allows them to
coordiate cursors with the editing tools (so we can switch to an arrow
when over a point).
We were running into various corner conditions where a tool's event
loop would exit while the tool was still active, or the tool would
get popped while we were still in the event loop. (A lot of these
had to do with the POINT_EDITOR's, but not all of them.)
The new architecture:
1) tools always do a Push()/Pop()
2) everyone is responsible for their own pops; no more stack-clearing
on a cancel
3) CancelInteractive events go to all tools to facilitate (2)
It's a bit of a hack because they're statically initialized and
so we can't make use of the _() macro. We do still want it in the
code, however, because the string harvesting is based off of it.
Fixes: lp:1833000
* https://bugs.launchpad.net/kicad/+bug/1833000
If a tool called something like clearSelection while processing a
MOUSE_CLICK, the SELECTION_TOOL will pass the clearSelection
COMMAND_EVENT because it handles it as a transition, not as an
event. Because m_passEvent is effectively global, the tool manager
would then interpret that as passing the MOUSE_CLICK and we'd end
up processing the click by multiple tools.
